| 路沿石必须挂通线进行施工 |
| 添加时间：2022/7/20 15:47:53 浏览次数： |
| 路沿石必须挂通线进行施工,按侧平面顶面示高标线绷紧，按线码砌侧平石，侧平石要安正，切忌前仰后合，侧面顶线顺直圆滑平顺，无高低错牙现象，平面无上下错台、内外错牙现象。 a. The road edge stone must be constructed by hanging a through line. It shall be tightened according to the height mark on the top surface of the side plane. The side flat stone shall be built according to the line code. The side flat stone shall be installed correctly. It is forbidden to close the front and back. The side top line shall be straight, round and smooth without high and low staggering teeth. The plane shall be free of up and down staggering platforms and internal and external staggering teeth. b.路沿石必须座浆砌筑，座浆必须密实，严禁塞缝砌筑； b. The stone along the road must be bedded with mortar, and the bedded with mortar must be dense. It is strictly prohibited to plug the joints for masonry; c.路沿石接缝处错位不超过1mm；侧石和平石必须在中间均匀错缝。 c. The dislocation at the joint of curbstone shall not exceed 1mm; the side stone and flat stone must be evenly staggered in the middle. d.路沿石侧平石应保证尺寸和光洁度满足设计要求。外观美观，对弯道部分侧石应按设计半径专门加工弯道石，砌筑时保证线形流畅、圆顺、拼缝紧密。弧形侧石必须人工精凿后抛光处理。 d. The size and finish of the curbstone shall meet the design requirements. The appearance is beautiful, and the side stone of the curve section shall be specially processed according to the design radius, to ensure smooth line, smooth circle and tight joint during masonry. The curved side stone must be chiseled and polished manually |
| 上一页 路牙石钢模具是以3-8毫米 |
| 下一页 模具零件裹面的组成 |
Copyright © 技术支持：遨游网络