| 生产出来的模具应该摆放整齐 |
| 添加时间：2019/6/15 14:58:35 浏览次数： |
| 1. 生产出来的模具应该摆放整齐，堆积的高度不要为了省空间，堆积的太高，而发生变形现象 1. The moulds produced should be placed neatly. The height of accumulation should not be too high to save space and cause deformation. 2. 入库必须严格检查，把不合格的模具挑选出来，严禁把一些过质的塑料混合物带进模具库房以免发展化学反应，模具韧性发展变化，从而直接影响生产出来的路沿石的规格。 2. Inspection must be strictly carried out to select the unqualified moulds. It is strictly forbidden to banzhi.37ix.com.cntiexinn.07858.netqingxiji.07858.netjilin.89ix.comshenyang.89ix.comxining.89ix.com bring some excessive plastic mixtures into the moulds storehouse in order to avoid developing chemical reactions and changing the toughness of the moulds, thus directly affecting the specifications of the roadside stones produced. 3. 模具库房应尽量保持干燥，通风，保持住一个很好的模具库房，定期检查库房温度和打扫库房卫生3. Mould warehouse should keep as dry and ventilated as possible, keep a good mould warehouse, check warehouse temperature regularly and clean warehouse hygiene. 4. 模具库房温度要适宜最好在25度以下，以免发展化学反应而影响模具的正常使用。 4. Mould warehouse temperature should be suitable below 25 degrees, so as not to develop chemical reactions and affect the normal use of the mould. 5. 在夏季模具库房一定要严格监控，发现有变色或者变形形象，马上隔离以免影响别的模具 5. Mould warehouse must be strictly monitored in summer. If discolored or deformed image is found, isolate immediately so as not to affect other moulds. |
| 上一页 大理石路牙石的加工 |
| 下一页 路沿石模具-缺角型路牙石模具 |
Copyright © 技术支持：遨游网络